Installation Guide

Page 6 of 10
Large/Wide CleanCut Ultra-Low
• The maximum top rail measurement to order a large/wide CleanCut Ultra- Low is 6.25”.
Sizing Note – Due to the design enhancement of more rounded corners on the top of the Ultra-Low
product, to be able to install on a bathtub with a top measurement of 6.0” you must measure
down 1” from the top of the step to begin tracing you template on the side of the step.
• The maximum bottom measurement to order a large/wide CleanCut Ultra- Low is 7.25”.
1. Take a stack of heavy card stock paper. This is the paper used to trace the cut- out section of the tub
onto the CleanCut Ultra-Low. Place the card paper onto the left end and trace the outline of the pattern
onto the paper. Once completed, mark this tracing as “Left”, so as to remember which side was traced.
It is also helpful to place an arrow on the template to indicate which direction is the inside of the tub.
2. Repeat the process for the right side of the tub. Mark this tracing “Right”.
3. Cut out the proper templates with scissors making sure to keep to the inside of the tracings.
FIGURE 2
4. It is time to transfer the shape of our cut tub onto the CleanCut Ultra-Low. Before continuing, it is
recommended that a drop cloth approximately 3’ x 4’ size be placed on the floor to prevent any dust or
other debris from transferring onto the CleanCut Ultra-Low.
5. Place the right end of the CleanCut Ultra-Low on the ground in order to trace the left side of the
CleanCut Ultra-Low. Place the top of the paper template approximately 1” from the top of the CleanCut
Ultra-Low (Figure 3). Place the tracing on the step so the slope is similar to that of the tub. Trace the
outline of the paper onto the CleanCut Ultra-Low with a continuous line. Continue the lines with a
straight edge down and around the corners. Repeat the same procedure for the right end of the
CleanCut Ultra-Low. Remember to place the paper template approximately 1” down from the top of the
CleanCut Ultra-Low before beginning to trace. Continue the lines with a straight edge down and around
the corners.