Installation Guide

Page 7 of 10

Next, place Convertible as shown and connect each side of the outside tub line using a yard

stick.

Use a tape measure and transfer the shape of the inside of the tub edge to the step. Remember that the tub

may be narrower in the center, so measurements for the inside line must be made every 3” from one end of

the CleanCut Convertible to the other. Once completed, use your yard stick and marker to connect the

markings for the inside line (Figure 4)

Cut the CleanCut Convertible to fit the cut-out tub opening using a jigsaw. (Figure 5). Fasten Velcro-

stripping on both sides of the jigsaw to prevent making any unwanted marks on the CleanCut Convertible.

It is important that a 2” blade is used to cut out the CleanCut Convertible so as to prevent accidentally

cutting through the top of the CleanCut Convertible frame.

Snap off any excess length on the stock jigsaw blade beyond 2”.

It is required that proper eye protection be worn while using the jigsaw. Cut the bottom of the

CleanCut Convertible using the jigsaw cutting directly on the center of the traced lines. Upon

reaching the corners while cutting, tilt the jigsaw outward to prevent cutting past your lines on the

vertical ends of the CleanCut Convertible. Remember to tilt your blade on each corner. On the

ends of the CleanCut Convertible, simply continue the cutting process with the jigsaw.