Installation Guide

Page 6 of 10
1. Take a stack of heavy card stock paper. This is the paper used to trace the cut-out section of the tub onto
the CleanCut Convertible. Place the card paper onto the left end and trace the outline of the pattern onto
the paper. Once completed, mark this tracing as “Left”, so as to remember which side was traced. It is
also helpful to place an arrow on the template to indicate which direction is the inside of the tub.
2. Repeat the process for the right side of the tub. Mark this tracing “Right”.
3. Cut out the proper templates with scissors making sure to keep to the inside of the tracings.
4. It is time to transfer the shape of our cut tub onto the CleanCut Convertible. Before continuing, it is
recommended that a drop cloth approximately 3’ x 4’ size be placed on the floor to prevent any dust
or other debris from transferring onto the CleanCut Convertible.
5. Place the left end of the CleanCut Convertible on the ground in order to trace the right side of the
CleanCut Convertible. Place the top of the paper template approximately ½” from the top of the
CleanCut Convertible. Place the tracing on the step so the slope is similar to that of the tub. Trace the
outline of the paper onto the CleanCut Convertible. Continue the lines with a straight edge down and
around the corners. Repeat the same procedure for the left end of the CleanCut Convertible. Remember
to place the paper template approximately ½” down from the top of the CleanCut Convertible.
Continue the lines with a straight edge down and around the corners (Figure 3).
FIGURE 2
PATTERN MARKS - - - - - - -
INDICATE THE AREA TO BE
CUT OUT ON THE RIGHT
END OF THE CONVERTIBLE.