Specifications

Mnl50005 (02-03) 7
OPERATION
CLEANING WITH ACCESSORY TOOLS
1. Attach solution and vacuum hose as described in
the “Machine Operation – Wand” section of this
manual.
2. Connect accessory tool and operate as normal
(Figure 11). Remember it is only necessary to
turn on the vacuum switch since activating it also
turns on the solution pump
NOTE: Before cleaning upholstery, always check
cleaning instructions sewn in furniture by
manufacturer.
3. After cleaning, relieve water pressure from tool
before disconnecting hose. Squeeze trigger for
five seconds after turning switches off.
DRAINING TANKS
DRAINING RECOVERY TANK
1. Turn machine off.
2. Insert supplied 45° elbow in drain valve. Place a
bucket below it and slowly pull up on the handle
(Figure 12).
3. Rinse tank with clean water and empty at the end
of the day.
FOR SAFETY: Remove all water from machine
before trying to lift it.
DRAINING SOLUTION TANK
1. Connect 3 foot utility hose to quick disconnect at
back of machine and turn on vacuum switch to
pump the water out or attach a vacuum hose and
evacuate water with vacuum motor running
(Figure 13).
FREEZE PROTECTION
Freeze protection will require the optional
accessory hose package and empty out nozzle.
1. After draining solution tank as described in step
one of the previous section (DRAINING
SOLUTION TANK), attach vacuum hose as if
preparing to clean with a wand.
2. Attach 3 foot long utility hose to quick disconnect
at the back of the machine.
3. Place end of utility hose in end of vacuum hose
and seal with hand (Figure 14).
4. Turn on vacuum (which also turns on pump) and
continuous spray switch for 30 seconds. This will
fill the pump and hoses with air and prevent
freezing.
Fig. 14
Fig. 13
Fig. 12
Fig. 11