Owner`s manual

Page 4 RX Express III
CleanMaster,
a Division of HydraMaster Corporation
1/10/00
CONTROLS
There are three switches installed in the dash box located on the main handle assem-
bly, one each for the vacuum pump, cleaning head, and solution pump. The handle
also contains a trigger for activating the solution valve.
MANEUVERABILITY
The ease of handling the RX-Express is a direct result of the rotary extractor head. Its
natural cleaning motion provides the “drive”
for the unit. The slightest push or pull against
the foam handle provides ample effort in
guiding the RX-Express through its cleaning
paces. Pivoting on its large front tires and
the swivel casters in the rear
allow the RX-Express to glide in and out of
tight spaces and turn on a dime.
CLEANING PATTERN
To achieve maximum results from your unit,
it is recommended that you clean in a back-and-forth motion while overlapping each
cleaning pass by fifty percent. The more soiled the area to be cleaned, the slower the
speed of the cleaning passes. This allows the machine more time to work. After
cleaning an area approximately six feet square, turn off the solution switch and make
vacuum-only “dry passes” over the area to assure maximum water removal and a
faster drying time.
Operation