Owner`s manual

RX Express III Page 3
CleanMaster,
a Division of HydraMaster Corpora-
tion
1/10/00
GROUNDING INSTRUCTIONS (cont.) :
The green (or green and yellow) conductor in the cord is the grounding wire. Never
connect the grounding blade to a live terminal. Your terminal is designed to be used
on less than 150 volts and has plugs resembling the one shown in Figure A. A
grounding adapter is available locally for connecting plugs to 2-prong receptacles.
The green (or green and yellow) right lug extending from the adapter must be con-
nected to a properly grounded outlet.
NOTE: Use only three wire extension cords which have three prong grounding-
type plugs and three prong receptacles or adapters that accept the appliance’s
plug. Replace or repair any damaged cords.
3. Always disconnect the machine from the electrical outlet before servicing.
4. Water heaters, when required, should be installed in-line, downstream of
this unit. Damage to the pumps will occur if water temperature exceeds
160 degrees.
5. Empty the entire machine of water before trying to lift it.
6. Do not allow the recovery tank to overfill with liquid or foam. If foam
occurs, a defoamer should be used.
7. After each use of the machine, rinse out and empty the recovery tank.
Then, with the recovery lid open and the vacuum hose off, run the
vacuum motor to allow the tank to dry.
8. Do not expose the machine to freezing temperatures.