Owner`s manual

Page 14 RX Express III
CleanMaster,
a Division of HydraMaster Corporation
1/10/00
Removal and Re-Installation of Solution Pump (cont.):
5. Disconnect wires at wire nuts.
6. Remake wire connections with new wire nuts.
7. Reinstall in reverse order.
Removal of Flow Control Valve:
1. Disconnect machine from power source.
2. Evacuate all water from unit.
3. Disconnect ¼" hose attached to valve.
4. Disconnect wires.
5. Unscrew the valve from the pump.
6. Lift complete valve assembly from unit.
Removal of Cleaning Head / Pivot Frame Assembly:
1. Disconnect machine from power source.
2. Remove vacuum hose attached to front of head.
3. Remove hose attached to rotary union.
4. Disconnect wires at rear of motor.
5. Remove control link from rear of shaft.
6. Loosen two (2) set screws in pivot bearing.
7. Remove spring from lifting mechanism.
8. Pull head forward to disengage from frame.