Owner`s manual

Page 6 RX Express III
CleanMaster,
a Division of HydraMaster Corporation
1/10/00
1. Fill the solution tank with hot water. The higher the temperature of the
water, the better the cleaning action of the machine and the chemicals
used. However, do not exceed a water temperature of 160 F. When
accessible, fill the machine directly from a utility sink. When this is not
an option, a clean, five gallon bucket will suffice. Add the necessary
chemicals. Now you are ready.
Only non-foaming cleaning solutions can be used and absolutely no harsh
solvents or petroleum products. They will decrease the life of rubber gaskets,
diaphragms and seals.
2. Attach the power cord to a properly grounded 20 amp receptacle.
3. Position the machine in the area to be cleaned.
4. Lower the cleaning head into its operating position by releasing the latch
located just behind the right front wheel.
5. Turn on the switches marked VACUUM PUMP, SOLUTION PUMP and
CLEANING HEAD.
6. To control the flow of solution, pull on the levers located on the handle.
7. When making a “dry pass” release the levers on the handles.
8. At completion, dispose of the dirty water in the correct manner. Also,
rinse the recovery tank thoroughly before reusing the machine.
NOTE: To remove any standing water in the solution tank before storing,
simply attach the three foot clear hose to the rear of the machine. Place
the other end of the hose in the recovery tank and turn on the pump to
evacuate the remaining water.
9. At the end of the day, perform the daily maintenance scheduled.
NOTE: The daily maintenance will prevent any chance of accidental
freezing.
Cleaning Instructions
CAUTION
!