Specifications

RX-Express
Page 3
5.
6.
7.
8.
9.
10.
the grounding blade to a live terminal. Your terminal is designed to be used on
less than 150 volts and has plugs resembling the one shown in Figure A. A
grounding adapter is available locally for connecting plugs to 2-prong
receptacles. The green (or green and yellow) right lug extending from the
adapter must be connected to a properly grounded outlet.
NOTE: Use only three wire extension cords which have three prong
grounding-type plugs and three prong receptacles or adapters that accept
the appliance’s plug. Replace or repair any damaged cords.
Always disconnect the machine from the electrical outlet before servicing.
Water heaters, when required,
unit.
Damage to the pumps
degrees.
should be installed
will occur if water
in-line, downstream of this
temperature exceeds 160
Empty the entire machine of water before trying to lift it.
Do not allow the recovery tank to overfill with liquid or foam. If foam occurs,
a defoamer should be used.
After each use of the machine, rinse out and empty the recovery tank.
Then, with the recovery lid open and the vacuum hose off, run the
vacuum motor to allow the tank to dry.
Do not expose the machine to freezing temperatures.
CleanMaster Corporation 4/21/98