Specifications

RX-Express

Page 11

threads before re-attaching the cleaning head to the machine.

WEEKLY...

Clean the lid thoroughly by removing the tanks and clearing the lid of debris.

2. Remove and clean the pick-up hose filter inside the solution tank with a vinegar

and water solution to remove the chemical deposits.

Check the applicator jets in the head to insure a proper solution flow. If the

flow is restricted, clean the jets. Twist the jet out. Turn it over. Blow out any

obstructions and reinstall the jet.

NOTE: Do not use any sharp objects to clear obstructions from the jets. This

will damage the jets.

UNEVEN

DRIBBLE

CORRECTLY

ATOMIZED

DAILY...

Clean off any accumulated debris on the gearbox shaft or inside the threaded portion

of the hub. An accumulation of debris around the gearbox shaft, if not removed, may

damage the gearbox oil seal resulting in loss of oil in the gearbox. If the gearbox is

operated without oil, severe damage may occur. (This requires removing the cleaning

head. To do this, please refer to the “REPAIR GUIDE” section. )

CleanMaster Corporation

4/21/98