Owner`s manual

HARDWARE
INSTALLATION
Mix Output Left (balanced)
Mix Output Right (balanced)
Network & POE
Power Supply (24V)
myMix CONTROL Interface
WiFi
Headphone
...
CAT 5
Fast Ethernet Switch
RX-2 to create a submix
RX-2 to feed
a wireless
IEM receiver
The myMix-Rx2 can be powered with the external 24V power supply or using POE
(Power-Over-Erthernet) from the switch (15W).
Connect the RX-2 to a myMix network using a CAT5 cable. As the RX-2 has no
user controls it has to be configured using the myMix Control interface, which
allows to access every unit on a myMix network using a web browser interface.
The optional RM-RX allows to mount up to three RX-2 in 1U, 19". Make sure that
the openings in the front and in the rear keep open and free from dust.
Optional RM-RX 19" rackmount kit for up to 3 RX-2 in 1U.
6
To configure and operate the RX-2 rack mixer you need the myMix Control
network interface that allows the editing of all myMix devices via a web browser
application on any capable device (computer, tablet, smart phone).
For how to operate myMix Control please see the myMix Control manual. There is
also a webinar that gives a quick introduction on how to operate myMix Control.
You‘ll find both of them at www.mymixaudio.com .
RX-2 has the same mixing capabilities as a standard myMix,with exception of the
two local inputs:
- Select audio channels from all available channels on the network which can be:
inputs to IEX16, inputs to myMix, stereo mixes from myMix
- A stereo mix can be created using volume, tone control, Stereo-FX send and Pan
- Channel Mute, Channel Solo and Master Mute
The RX-2 will show up on the „myMix-Select“ page in myMix Control. To configure
hit the „Edit“ button, like on any myMix. You can copy profiles between myMix and
RX-2.
Note: myMix and RX-2 can only select stereo-mixes as inputs when „Send Mix to
Network“ is deactivated.
There are a various applications for in a myMix system, typical are:
- to transport a mix that is created on stage to a remote location (e.g. to a wireless
transmitter or amplifier) using the network cabling
- to create a submix within the myMix system that is controlled by an engineer
RX-2
UPDATING FIRMWARE
Check on www.mymixaudio.com for the latest firmware updates. We recommend
not mixing units with different firmware versions on the same network. The firmware
update requires a myMix unit and a temporarily free SD card. To update the firmware:
1. Format SD card in myMix (ADMINISTRATION screen)
2. Download the latest firmware from www.myMixaudio.com/support
3. Unpack and save the firmware files (extension .blob) on the SD card.
4. Insert the SD card in the myMix, go to > Settings > Aministration
5. Select: „Update Remote Device“
6. Connect the RX-2 with a CAT5 cable to the myMix and power it.
7. The RX-2 will now boot and automatically start the update process.
8. . After aprox. 2 minutes the RX-2 will start flashing (blue LEDs inside)
9. . Now press „Done“ on the myMix and power cycle the RX-2.
7
OPERATION