Installation Instructions

WWW.CLEANCOMFORT.COM
4
IO-UC36D16-DV
SYSTEM INSTALLATION
Step 1
Figure 1)
Step 3
Mount base plate to duct - 4 screws. (Figure 3a)
WARNING!
DO NOT connect electrical power while installing.
CAUTION!
Step 2
Cut access hole in duct. (Figure 2)
Figure 1
Figure 2
Figure 3a
Figure 3b
Locking tab
NOTE: Use 4 inside pre-cut holes for duct board
Step 4
Insert lamp into the back of the UV module. Squeeze
locking tabs on lamp base to secure lamp. (Figure 4)
For duct board, mount base plate as shown, using 4 nuts,
bolts and washers. (Figure 3b)
Figure 4
Power outlet
Safety switch
Power Module