Installation Instructions

ManualsBrandsClean Comfort ManualsAir PurificationUC Series® - Ultraviolet Coil Purifier for Furnaces - 16" Dual UV-C Lamps - 24V/120V - High Temp

COIL PURIFIERS

www.cleancomfort.com

IO-UC36D16-DV

PREMIUM PLUS

DUAL LAMP, DUAL VOLTAGE

UV COIL PURIFIERS

For Furnace Installations

UC36D16-DV and UC36DL16-DV

UC36DL16-DV

Features Programmable LCD

Service Notification Screen

UC36D16-DV

High Temp model for High Ambient

& High Humidity Environments

Installation Instructions

Features

•

• 16" Dual UV-C lamps

• Includes 360°

•

• Dual Voltage – 120V or 24V power

• Built in UV “Smart Light” Photo cell indicator

•

• Convenient Snap in/out lamp

for quick servicing

• High Temp model – Up to 220°F (104°C)

• 5 year limited warranty on power supply

• 1 year limited warranty on lamp

Dimensions: 6½" L x 6½" W x 18½" H

Electrical: 120VAC, 60Hz, 0.35A; 36W lamp

24VAC, 60Hz, 1.5A; 18W lamp

Weight: Less than 2 lbs

Humidity: Water-resistant lamp

Lamp life:

Lamp Replacement Model: UCP-36D16-DV

Summary of content (12 pages)

PAGE 1
COIL PURIFIERS PREMIUM PLUS DUAL LAMP, DUAL VOLTAGE UV COIL PURIFIERS Features • • 16" Dual UV-C lamps • Includes 360° For Furnace Installations • • Dual Voltage – 120V or 24V power • Built in UV “Smart Light” Photo cell indicator • UC36D16-DV and UC36DL16-DV Installation Instructions • • • Convenient Snap in/out lamp for quick servicing • High Temp model – Up to 220°F (104°C) • 5 year limited warranty on power supply • 1 year limited warranty on lamp Dimensions: Electrical: Weight: Humidity: 6½" L
PAGE 2
TABLE OF CONTENTS PRODUCTS .......................................................... SYSTEM INSTALLATION PROGRAMMING ..................................... 4 ................................................ 7 MAINTENANCE & WARRANTY Proprietary Notice ......................... 10 *INSTALLATION DATE (MM/DD/YYYY) proprietary data of Daikin North America LLC.
PAGE 3
READ BEFORE INSTALLING Instalation Instruction Products WARNING! Power supply can cause electrical shock. Be sure the UV power supply is disconnected before Model - UC36D-DV Model - UC36DL-DV WARNING! High temperature model with programmable LCD display Do not open the base unit as it is designed to be installed as one piece. There are no service components inside. WARNING! WARNING! Do not touch lamp glass without gloves. Keep lamp surfaces clean. WARNING! Lamps may contain small amounts of mercury.
PAGE 4
SYSTEM INSTALLATION WARNING! CAUTION! DO NOT connect electrical power while installing. Step 1 Step 3 Figure 1) Mount base plate to duct - 4 screws. (Figure 3a) Figure 3a Figure 1 For duct board, mount base plate as shown, using 4 nuts, bolts and washers. (Figure 3b) Step 2 Cut access hole in duct. (Figure 2) Figure 3b NOTE: Use 4 inside pre-cut holes for duct board Step 4 Insert lamp into the back of the UV module. Squeeze locking tabs on lamp base to secure lamp.
PAGE 5
SYSTEM INSTALLATION Step 5 Step 6 Note: device is installed where the UV light is shining on the coil or in the cold air return duct. Then, insert metal locking clip into holes as shown. (Figure 6 - A, B, C) Insert clip under small glass bridge at lamp end. (Figure 6a) (Figure 5a) Glass Bridge  Figure 5a Metal locking clip Figure 6a Turn clip end down to lock into place.
PAGE 6
SYSTEM INSTALLATION Step 7 Figure 7) Locking slot Locking tab UV-C lamp Locking slot Safety switch pin Figure 7 Locking tab Step 8 For 36W models Install power cord & connect to 120V power supply. For 18W models install to 120V or 24V power supply. For 24V power supply, cut plug and connect wires to 24V power source. Power up unit. Check that blue UV indicator light is illuminated. (Figure 8) UV indicator light Tandem access door Figure 8 6 WWW.CLEANCOMFORT.
PAGE 7
TANDEM INSTALLATION Step 9 - Tandem installa�on - NOTE - 120 Volt ONLY. Figure 9a). Connect units together. (Figure 9b) Press on one side of tandem access door to remove To power Figure 9a Connect power cord to join units (Figure 9b). UV COIL PURIFIERS To power Figure 9b IO-UC36D16-DV WWW.CLEANCOMFORT.
PAGE 8
PROGRAMMING Programming P3 - Character screen For LCD versions only screen. (Figure 11) P1 - The LCD There are 3 rotating screens: 1. Clean Comfort logo 2. Number of days remaining before service 3.
PAGE 9
PROGRAMMING P4 - Editing text When you land on the character you need, depress the P5 - Saving your information character into memory. of 16 characters per line. used to program the LCD screen of any UC36DL16 on your next install. Simply power up and insert the on the next page. (Figure 14) UV module’s permanent memory. For assistance, contact 1-866-876-8044 or 1-416-615-0214 between 8 AM and 4 PM Eastern Standard Time.
PAGE 10
MAINTENANCE & WARRANTY Maintenance of this product contact us at: NOTICE DAIKIN NORTH AMERICA LLC lamps at least once a year, even if the lamp appears to Replacement UV-C lamps can be obtained from your installing contractor or by calling Daikin at 1-866-876-8044. Warranty Daikin North America LLC warrants these products, to the original consumer, to be free from defects in materials and period listed below.
PAGE 11
NOTES Notes: IO-UC36D16-DV WWW.CLEANCOMFORT.
PAGE 12
COIL PURIFIERS © 2014 DAIKIN NORTH AMERICA LLC Houston, Texas • USA Email: info@cleancomfort.com • 1-866-876-8044 IO-UC36D16-DV WWW.CLEANCOMFORT.