Installation Manual

INSTALLING DUCT COLLARS
IO-DV090 IO-DV090
WWW.CLEANCOMFORT.COM
7
Aach three white plates
using three #8 screws
provided to create a 10" plug
Aach the 10" plug to rear
of the dehumidier using
six #8 screws
Aach the second 10" duct
collar as you did the rst.
Using six #8 screws provided.
90° Flow
Step 3. Choose desired orientaon for
10" diameter supply duct collar:
A. Straight through (180°) ow
B. Upward, out of the top (90°) ow
Remove the 10" circular knock out from top panel
of dehumidier using side cuers.
-OR-
Recycle three plates and nine extra screws.
These are only used for 90° ow opon
.
180° Flow
Aach the second 10" duct collar as you did the rst.
Use six #8 screws provided.
Ducting for Dehumidication
For the ideal installaon, draw air from the central part of
the home and return it to the isolated areas of the home
like the bedrooms, den, ulity room, or family room. Be
sure to ulize as many of these remote rooms as possible
and not just one locaon. The ductwork of the exisng
HVAC system can be used to supply air to the home. If
the exisng supply goes to isolated areas of the home,
discharge the supply from the DV090 into the supply duct
of the exisng HVAC system. If the exisng heang system
incorporates a central supply, installaon of a separate
supply duct from the DV090 to each isolated area is
recommended.