Installation Manual

DUCTING
Figure 2B
Note: If not using
venlaon damper,
do not remove
knock out.
IO-DV090 IO-DV090
WWW.CLEANCOMFORT.COM
6
Figure 3
Step 2. Aach the 10” diameter return duct collar using
six #8 screws provided.
Adjust damper to desired posion. Open (Fig 2G) or closed (Fig 2E)
Figure 2E
Figure 2G
Figure 2F
Fasten duct collar to cabinet using four #8 screws provided. (Fig 2F)
Note desired orientaon of damper control lever. (Fig 2E)
Remove knock out using side cuers. Discard
Figure 2D
Figure 2A:
Aaching duct collars to the DV090
Step 1. Aach 6” diameter fresh air venlaon
damper. (if desired)
Safety Float Switch the DV090 and the dehumidier will
shut o. If the blue wire is in series with the Safety Float
Switch the compressor will turn o but the DV090 will
connue to venlate or circulate air as normal. Contact
your local electrician to install the safety oat switch
directly to the dehumidier.
For installaon guidelines, refer to the "Condensate Pump
Installaon" secon at the back of this manual.
Ducting
Installing Duct Collars
The DV090 comes supplied with 10” and 6” round inlet
collars and a 10” round exhaust collar. Follow instrucons
included with these collars.
Figure 2C