Installation Manual
MAINTENANCE
IO-DV090 IO-DV090
WWW.CLEANCOMFORT.COM
13
Maintenance
For Homeowner - Routine Maintenance
Part No. Description
DVP-4034733 14"x14"x1" MERV 11 lter for
DV090 dehumidier
High Eciency Air Filter
The Clean Comfort Venlang Dehumidiers are
equipped with a MERV 11 media lter. This lter should
be checked every three months and changed every 6-12
months. Operang the unit with a dirty lter will reduce
dehumidier capacity and eciency and may cause the
compressor to cycle OFF and ON unnecessarily on the
defrost control.
I
CAUTION!
DO NOT operate the DV090 dehumidier without the
MERV 11 lter or with a lter of lower performance
rang than MERV 11. The heat exchange coils inside
the unit could become clogged and require disassembly
to clean. Non-compliance with lter maintenance
guidelines (provided above) invalidates the product
warranty.
Service Parts List: Clean Comfort DV090
Ventilating Dehumidier
Part No. Description
DVP-4034804 Transformer, 120/24VAC, 40 VA
DVP-4034807 Defrost Control
Figure 8: Wiring Schemac for DV090
Wiring Schematic
I
WARNING!
Servicing the DV090 with its high pressure refrigerant
system and high voltage circuitry presents a health
hazard which could result in death, serious bodily injury,
and/or property damage. Call your HVAC contractor
for servicing or repair of this equipment.
To replace the lter, remove the lter door from the side of
the DV090 dehumidier by gently pulling it away from the
body of the unit.
Remove the lter by gently pulling straight out of the unit.
Insert new lter in the same manner, pushing it gently
straight into the unit. Replace lter door.
Impeller Fan Oiling
The impeller fan motor is factory lubricated for many
years of normal operaon, and no further oiling
is required.
Optional Fresh Air Intake
Check and clean the screen on the outdoor fresh air intake
port seasonally. The screen may become plugged during the
seasons when there are many parcles in the outdoor air.
Service
Warranty
A consumer warranty cercaon is included at the end of
the manual. Please read it before any repair is iniated. If a
warranty repair is required, call the installing contractor or
the factory at 1-855-239-2665 for warranty claim authori-
zaon and technical assistance.
To
dehumidier
control