User's Manual

8
Insert the T-flash Card：Push the card into the card tray
with the metal side down; the card will be fixed when you hear a
“click” sound.
Taking out the T-flash Card：Take out the battery first and
push the T-FLASH socket , and then you can take out the T-flash
card.
2.3 Battery
The new battery has about 50% capacity. You can use it
immediately. The new battery must be charged at least 14 hours,
the full performance of a new battery is achieved only after two
or three complete charge and discharge cycles
2.3.1 Insert and take out the battery
 Follow the below procedures to take out the battery
1. Push downward the battery cover away.
2. Take out the battery from the bottom of the battery.
 Follow the below procedures to insert the battery.
1. Press the battery into the battery slot tightly.
2. Push the battery cover into battery tary.
2.3.2 The charge of battery
Contact the charger with power supply.
Insert the joints of charger into the bottom of the phone.
Then the battery capacity sign on the top right corner of
the screen will flash circularly. If you are charging the phone
when it’s turned off, the screen will display the charging
animation. If the battery is completely discharged, it may take a
few minutes before the charging indicator appears on the display
or before any calls can be made.
It means the battery has been fully charged if the battery
capacity sign shows that it’s full and stops flashing. If the phone
turned off, the screen will tell you that the battery is full. This will
need 3 ~4 hours. It’s normal that when charging the battery, the
temperature of the phone, battery and charger will rise.
When the battery is fully charged, disconnect the electric
resource and the phone.