User manual

8
The table below gives the recommended minimum wire cross sections for the AC mains
cables.
1012(-50)
1312(-80)
1512(-80)
2012(-100)
1024(-30)
1524(-40)
2324(-50)
mm
2
1 mm
2
1 mm
2
1 mm
2
1,5 mm
2
1 mm
2
1 mm
2
1,5 mm
2
AWG
17 AWG
17 AWG
17 AWG
15 AWG
17 AWG
17 AWG
15 AWG
Table 2 Recommended minimum AC cross section.
Warning: Do not connect the AC outputs in parallel or serial. It will damage the device
and is not covered by the warranty.
Warning: Do not connect a generator or AC mains to the output (gray neutrik). It will
damage the device and is not covered by the warranty.
Note: Using RCD devices is highly recommended in any installation. The schematic below
shows a recommended installation of an RCD.