User manual

The device can also be activated by placing a voltage on the remote pin of one of the three

connectors on the front of the device. This is illustrated in the schematic below.

If the device is connected to a Clayton Power Lithium battery with data the inverter will by

default start when the battery is activated. To change this behavior, please refer to the Clayton

Power Lithium Battery User Manual.

Note: if the battery is discharged the red LED will continue to light. Recharge the battery and try

again.

Inverter Load Search Mode

The inverter can be put into load search mode to lower the standby power consumption.

When the inverter is in load search mode, the inverter will automatically shut down when the

AC load is lower than 10 W. The inverter will turn on every 2 seconds and detect if a load is

present.

Press duration

Precondition

Function

2 seconds

Inverter mode is Off

Turn on inverter mode

1 second

Inverter mode is On

Turn off inverter mode

10 seconds

Inverter mode is Off and

not in load search mode

Unit enters load search mode

All LEDs lights solid

10 seconds

Inverter mode is Off and

not in load search mode

Unit exits load search mode

All LEDs blink

Note: When using the device with a Clayton Power Lithium battery it is not advised to use

load search mode.