Specifications

The wizard makes setup easier because it automates what would otherwise be a more complex
set of individual setup steps. It also reminds you to perform important tasks such as setting the
date and time and configuring a log server.
The steps that the wizard goes through after the welcome screen are listed next.
Wizard step 1: Enter a new username and password
You will be prompted to enter a new administration username and password as shown below. It
is recommended that this is always done and the new username/password is remembered (if
these are forgotten, restoring to factory defaults will restore the original admin/admin
combination). The password should be composed in a way which makes it difficult to guess.
Wizard step 2: Set the date and time
Many CorePlus functions rely on an accurate date and time, so it is important that this is set
correctly in the fields shown below.
Wizard step 3: Select the WAN interface
Next, you will be asked for the WAN interface that will be used to connect to your ISP for Internet
access.
Chapter 3: CorePlus Configuration
26