Setup guide

Tip
When entering IP addresses, use the "." (period) key to move the console cursor
from one part of the IP address input field to the next.
The Default Gateway does not need to be specified if the management workstation is local. If,
however, the management workstation is at least one router hop away from the appliance then
the Default Gateway needs to be specified so that the appropriate entry is placed in the
CorePlus routing table which is otherwise empty. Specifying the Remote Mangement Net is
also required if the management workstation is not local.
Note
It is possible to use DHCP on the interface.
4. The following will appear in the terminal window:
Press Y to start CorePlus.
5. You will the receive a confirmation message that CorePlus has successfully started as shown
below:
3.2. Local RS232 Console Setup Chapter 3. Initial Setup
16