Setup guide

3.2. Local RS232 Console Setup
Make sure that a terminal (or a computer running terminal emulation software such as
Hyper-Terminal) is connected to the console port on the Clavister SG3200 Series hardware as
described above in Section 3.1.2, “Connecting the Console Port”.
1. Having previously followed the instructions in Section 2.2, “Connecting Power”, the device
should now be powered up.
Note
The hardware will require a short amount of time go through it's initial power up
sequence and during this period there will be no output to the console.
When the appliance becomes operational, output similar to the following will appear on the
console:
2. Select the interface that you have chosen for communication with the management station.
Then press Enter to confirm your choice.
3. Enter the IP address you intend to use for the management interface and enter the appropriate
netmask and default gateway. It is also possible to specify a remote management network if it
is different from the local management interface subnet. Press Ctrl-S to save the settings and
continue.
3.2. Local RS232 Console Setup Chapter 3. Initial Setup
15