Setup guide

2.2. Connecting Power

This section describes connecting power to the SG3200. Power should not actually be switched on

using the On/Off switch until after the local console has been connected as described in

Section 3.1.2, “Connecting the Console Port”. The reason for this is that as soon as power is applied

the boot-up dialog sequence will appear on the console screen.

Figure 2.1. SG3200 Rear View

Important

Please read the advisory concerning electrical safety in Chapter 5, Safety.

Connecting AC Power

To connect power, follow these steps:

1. Fit the power cord into the power adapter that comes with the SG3200 Series.

2. Plug the power adapters power plug into the power receptacle on the back panel of the SG3200

Series device.

3. Plug the other end of the power cord into a grounded power outlet.

4. After a console is connected as described in the following section, power on the appliance

using the switch at the back of the unit.

2.2. Connecting Power Chapter 2. Installation