Specifications

3.2. DIN Rail Installation

The X8 is designed for DIN rail mounting only and comes delivered with a rotatable DIN bracket

at the back for mounting. This DIN bracket can be rotated in 90 degree increments and can be

easily removed if not needed. The DIN bracket is shown in the image below.

Figure 3.1. The X8 Rear Showing DIN Attachment

Warning: The X8 should not operate on a flat surface

Since all cooling in the X8 is achieved through heat exchange between the unit's sides

and the surrounding air, it must not be placed on a flat surface, such as a table, during

operation.

Chapter 3: X8 Installation