Specifications

NORD STAGE Eighty Eight V1.1x 9. The Morph Assign feature: Morph Assignable parameters
Page 55
5. Hold down the W
HEEL
button in the Morph Assign section again while turning the Instrument
L
EVEL
knob that was set to minimum value in Step 2 up to maximum value.
6. Release the W
HEEL
button in the Morph Assign section.
7. When you now move the Wheel, the Level is gradually lowered for one instrument and raised for the
other instrument, allowing you to “morph” between the two instruments!
MORPH ASSIGNABLE PARAMETERS
Basically you can use the Morph function to control all rotary encoders (knobs that show parameter values
with LEDs) and the organ drawbars. Apart from the number of assignable parameters, there is no limit to
how many parameters you can control simultaneously using Morph.
The following parameters can be Morph controlled:
• The L
EVEL
knobs for all Instrument sections.
• The T
IMBRE
knob in the Synth section.
• The F
ILTER FREQUENCY knob in the Synth section.
• The D
RAWBARS
in the Organ section.
• The Effect R
ATE
/T
EMPO
knob.
• The Effect A
MOUNT
knob.
• The P
ARAMETER
knob in the Extern section (see page 58).
• The R
OTOR SPEED
button - Note that this is not visible! E.g. hold down the W
HEEL
button in the
Morph Assign section, and press the R
OTOR SPEED
button once. Now the Wheel controls the Rotor
Speed. Note also that this enables you to set Rotor Speed continuously, instead of just alternating
between two fixed speeds. To deactivate, hold down the W
HEEL
button in the Morph Assign section,
and press the R
OTOR SPEED
button again.