Specifications

NORD STAGE Eighty Eight V1.1x 5. The Program section: Storing Programs
Page 19
STORING PROGRAMS
Storing a Program will overwrite the existing Program in the selected memory location.
Note! When Nord Stage is shipped from factory, Memory Protect is set to ‘On’. To be able to
store Programs, see “Memory Protect” on page 61.
S
TORING A
P
ROGRAM
To store a Program without changing its name, proceed as follows:
1. Press the S
TORE
button once. The S
TORE
button and the cur-
rently selected P
ROGRAM
button indicator starts blinking, and
the D
ISPLAY will read “Store to X : X” (the current Page and Pro-
gram number), plus the Program name,
2. Next step is to select a Page/Program location to store the edited Program in. You can use the P
AGE -
/+ buttons to select a Program Page (1-21), and the P
ROGRAM 1-6 buttons to select a Program
number on the selected Page (or the Live 1 or 2 memories). Alternatively, you can use the V
ALUE
D
IAL
to scroll through all Programs (on all Program Pages). To cancel the operation, press any but-
ton, except for the S
HIFT, PROGRAM, STORE or PAGE -/+ buttons.
• From here you can opt to name the program before finally storing it - see “Naming a Program” below.
3. Press S
TORE
again to store your Program. The Display now reads “Program Stored!” for a short dura-
tion.
N
AMING A
P
ROGRAM
To name a program, proceed as follows:
1. Hold down S
HIFT
and press the S
TORE
button once. The S
TORE
button indicator starts blinking,
and the D
ISPLAY
will read “Set Name”.
2. Now use one of the following methods to name your Program:
• You can move the cursor position left or right in the D
ISPLAY
by using the P
AGE -/+ buttons.
• When the cursor is at the position where you want to enter/change a character, you can use the V
ALUE
D
IAL
to scroll through all available characters (a-z.A-Z, 0-9, Space and “-”).
• By holding down S
HIFT
and pressing the P
AGE + (INS) button, you enter a blank step at the cursor
position.
• By holding down S
HIFT
and pressing the P
AGE - (DEL) button, you erase the character at the cursor
position.
• Alternatively, you can press and hold down the KB Z
ONES 2 OR 3 button. This will bring up the char-
acters in the D
ISPLAY
with the focus on the character the cursor was last on. You can now use the
V
ALUE DIAL
to select a character at the current cursor position. When you release the KB Z
ONES but-
ton the cursor automatically moves to the next position.
3. Press S
TORE
again. Now you can use the same methods as outlined in “Storing a Program” above to
store your name with the Program.
Store to 1:5
Wizard