User manual

System Functions User Manual
16
THE SOUND MENU1-16 Note messages are sent on the corresponding MIDI channel
using the fast trigger mode, with fixed velocity data (use
this when recording MIDI events in sequencer for internal
playback). MIDI IN is enabled.
E1 - E9 Note messages are sent on the corresponding MIDI channel
using normal trigger mode, with velocity sensitive data (use
this when controlling other sound sources). MIDI IN is dis-
abled.
2 Lower Channel default value: 2
Same as above, only for lower manual.
3 Bass Channel default value: 3
Same as above, only for controller connected to BASS PEDAL input
and lower section of lower manual when split mode is active.
Note: the BASS PEDAL input is always in OMNI mode.
4Local Control default value: ON
Determines if the organ should respond to local controls (keyboard,
knobs and buttons).
ON Local control is enabled.
OFF Local Control is disabled.
5 Continuous Controller mode default value: SR
Specifies how the front panel’s knobs and buttons are handled via
MIDI.
SR Messages are sent and received.
R Messages are received only.
S Messages are sent only.
OFF Messages are neither sent nor received.
6 Program Change mode default value: SR
Specifies how Program Change messages are handled via MIDI.
SR Messages are sent and received.
R Messages are received only.
S Messages are sent only.
OFF Messages are neither sent nor received.
7 Send Continuous Controller messages
Press STORE to send the current state of the selected organ model’s
buttons and knobs as Continuous Controller messages via MIDI.
Common parameters (including ROTARY SPEED and SWELL) and
Upper-specific parameters are sent on the Upper Channel. Lower-spe-
cific parameters are sent on the Lower Channel. Bass-specific parame-
ters are sent on the Bass Channel.
Note: Messages are not sent if Channel setting is set to “OF”.
8Dump One
Press STORE to send the current program as sysex messages via MIDI.
9Dump All
Press STORE to send all stored program data as sysex messages via
MIDI.
1 Treble Horn Speed default value: NO
Adjusts the speed setting (fast and slow-speed) of the rotary speaker
simulation’s horn.
HI
High.
NO Normal.
LO Low.
2 Treble Horn Acceleration default value: NO
Adjusts the acceleration and retardation time of the rotary speaker
simulation’s horn.
HI High.
NO Normal.
LO Low.
3 Bass Rotor Speed default value: NO
Adjusts the speed setting (fast and slow-speed) of the rotary speaker
simulation’s rotor.
HI
High.
NO Normal.
LO Low.
4 Bass Rotor Acceleration default value: NO
Adjusts the acceleration and de-acceleration time of the rotary
speaker simulation’s rotor.
HI
High.
NO Normal.
LO Low.
5 Tonewheel mode default value: V1
Controls the level of tonewheel crosstalk and cable leakage artefacts
of the Tonewheel organ.
V2 Vintage 2: high level of artefacts.
V1 Vintage 1: medium level of artefacts.
CL Clean: low level of artefacts.
6 Percussion Fast Decay Time default value: NO
Adjusts the fast mode decay time of the Tonewheel percussion effect.
LO Long.
NO Normal.
SH Short.
7 Percussion Slow Decay Time default value: NO
Adjusts the slow mode decay time of the Tonewheel percussion
effects.
LO Long.
NO Normal.
SH Short.