Operation Manual

GB
32
Special safety instructions for this device
Symbols on the Product
On the products you will fi nd symbols that indicate warnings or provide information:
Warning of electric shock!
Do not use this device near baths, wash basins or other
vessels containing water.
• Warning: The nozzles become hot during operation.
• If the hair dryer is used in the bathroom, remove the mains plug after use as water
represents a hazard. This also applies when the hair dryer is switched off.
• Do not put objects, hair or your hands in front of the air intake opening! The device can
suffer damage despite the overheating protection if the airfl ow is blocked!
• Please ensure that the inlet grille remains free of fl uff and hairs. Danger of fi re!
• As additional protection we recommend the installation of a fault current protection
device (RCD) with a rated current of not more than 30 mA in the wiring system of the
bathroom. Please contact an authorised electrician for advice.
Neu.indd 325-HT 3215 Neu.indd 32 01.12.2008 12:04:57 Uhr01.12.2008 12:04:57 Uhr
Commissioning
1. Fully unwind the mains cable.
2. Make sure that the iron voltage (see name plate) and the mains voltage match.
3. Insert the plug into a duly installed 230V/50Hz protective contact socket.
4. Shift the switch on the handle to one of the desired heat/blowing levels:
Level 0: off
Level 1: medium airfl ow and medium temperature
Level 2: strong airfl ow and high temperature
Switch-off
• After use shift the switch to position „0“ and pull out the plug. Leave the device to cool
before putting it away!
• To this purpose you can place the device on one of the rubberised sides of the housing
• Store the device in the see-through bag.
Cleaning and care
• Before cleaning remove the mains lead from the socket.
• Clean the housing with a soft, dry cloth without additives.
• The device must never be immersed in water!