Operation Manual

GB
30
Commissioning
1. Fully unwind the mains cable.
2. Make sure that the iron voltage (see name plate) and the mains voltage match.
3. Fit on a nozzle. You can dry single hair locks by concentrating the fl ow of hot
air with the hairdressing nozzle.
4. Insert the plug into a duly installed 230V/50Hz protective contact socket.
5. Shift the switch on the handle to one of the desired heat/blowing levels:
Level 0: off
Level 1: medium airfl ow and medium temperature
Level 2: strong airfl ow and high temperature
Switch-off
After use shift the switch to position „0“ and pull out the plug. Leave the device to
cool before putting it away!
Cleaning and care
• Before cleaning remove the mains lead from the socket.
• Clean the housing with a soft, dry cloth without additives.
Mains Cable
• The mains cable should only be wound up loosely.
• Never tie the cable tightly round the device, as over time this may result in the
cable breaking.
• Check the mains cable regularly for damage.
Air Intake Grill
Please clean the grill on the air intake side of the hairdryer regularly in order to
avoid excessive temperatures as a result of heat accumulation.
Technical Data
Model: .........................................................................................................HT 2996
Power supply: ....................................................................................... 230 V, 50 Hz
Power consumption: ..................................................................................... 1600 W
Protection class: ..................................................................................................... ΙΙ
05-HT 2996 30 08.09.2005, 9:01:48 Uhr