Operation Manual

45
GB
Inserting of the battery (Battery is not included in the scope of delivery)
1. Turn the bottom cover and pull it off.
2. Insert a 1.5 V battery of the type MIGNON AA into the battery com-
partment. The positive pole (+) has to show towards the shaving
head.
3. Close the battery compartment again: Turn the cover onto the
device until it engages with a click. The attened part of the cover
must be positioned exactly under the attened part of the device
(see Fig.).
Usage
1. Pull the protective cap off.
2. Slide the switch towards “0” in order to turn on the appliance.
3. Guide the tip of the shaving head into the nostril or auricle.
WARNING:
Only remove the prominent nose or ear hair. Do not forcefully push the appliance into
the nostril / auricle. You can hurt yourself when it is inserted too deep!
4. Slide the switch back towards “1” after usage in order to switch off the device.
5. Clean the shaving head with the cleaning brush after usage.
6. Set the protective cap onto the device.
Cleaning
WARNING:
• Do not submerge the unit in water.
• The cutting blade is sharp. Do not touch it! There is the danger of injuries.
CAUTION:
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
1. Switch off the appliance before cleaning.
2. Remove the battery from the battery compartment.
3. Loosen the shaving head by turning it anticlockwise and remove it. Remove the cutting
blade holder carefully.
4. Remove remaining hair from the blade holder using the cleaning brush. You can also
blow off the remaining hair from the holder.
5. Replace the cutting blade holder into the cutting head.