Operation Manual

GB
40
• Push two of the supplied attachments on to the heating surfaces of the device. Please
note the guide mechanism. Then push the plate downwards until it locks in place.
Thick-toothed accessories: to make large waves in hair,
for greater hair volume.
Fine-toothed accessories: to make small waves in hair
Flat accessories: for smooth hair
General Use
• Insert the plug in a duly installed 230V/50Hz socket.
 NOTE:
The red LED lights up. After approximately 5 minutes the device is ready to use.
• The device must be used only for dry hair.
• Take a strand of hair and pull it carefully downwards until it is taut.
• The remaining hair should be put up or xed in place. Before the halves are pressed
together for approx. 5 seconds, we recommend that you ensure that the hair is positi-
oned correctly.
• Always begin at the base of the hair and move the device in the direction of the hair
tip.
• In order to produce a uniform appearance it is important that the next strands fall in
one line.
• To ensure that the waves are retained for a prolonged period we recommend that you
use only a coarse comb or your ngers.
WARNING!
Leave the appliance to cool before changing the accessories!
CAUTION:
Mount the accessories in pairs on the heating surfaces (2 for large hair waves, 2 for
small hair waves or 2 for smooth hair) to avoid damaging hair!
• Please remove the mains plug after use. Leave it cool for a few minutes before putting it
away.
Styling Tips
• In order to achieve a pronounced crimping effect, please apply gel or hairspray before
using the device (it is possible that the hair will produce a little „steam“ or „vapour“ - but
this is normal).
05-HC 2847.indd 40 25.09.2009 14:39:15 Uhr