Operation Manual

52
Themen
1. Open and remove the battery compartment cover.
2. Insert two batteries of type AAA/R03 (1.5 V), ensure correct polarity
(+ and -). Start with the negative pole (-).
3. Attach and close the battery compartment cover.
 NOTE:
The signals from the remote control are transmitted to the DVD-Player by
infrared light. You should therefore take care that the DVD-Player is not
exposed to the direct sunlight. This could make the transmission of signals
from the remote control to the DVD-Player impossible.
Effective range of the remote control
If you want to use the remote control it has to be pointed at the remote control
sensor on the front of the device. The distance between remote control and
sensor should not exceed 7m. The angle of the remote control to the remote
control sensor to right, left, top and bottom should not exceed 30°.
The video cable transmits the video data from your DVD-Player to the TV or
the Video-Projector.
There are four different ways of connecting the DVD-Player with your TV/
Video-Projector. Select one of these possibilities to suit your replay unit.
 NOTE:
If you do not use a SCART connection it is necessary to make an additional
audio connection for the transmission of the audio data (i.e. the sound).
SCART
SCART is used to transmit both Video and Audio data.
1. Plug the SCART jack fi rmly into the socket on the back of the player.
2. Plug the SCART jack into the corresponding socket on your playback
device.
Connecting the Video cable
Fig. 2/14
Starting up
05-DVD 755 HC GB 52 05.04.2007, 12:37:04 Uhr