Operation Manual

44
This function can only be used if the station
which is set offers teletext.
ÖIn order to exit the teletext, press the ”EXIT“ but-
ton.
Selecting an audio setting
This setting can be used to switch between stereo,
and (mono) left or (mono) right.
ÖIn order to change audio settings, press the
”LANGUAGE L/R“ button during operation.
ÖPress the “ VOL+” button until the required set-
ting is displayed.
ÖPress the ”EXIT“ button, in order to return to the
normal screen display.
Recall
ÖTo call up the channel which was last selected
again, press the “RECALL” key.
Removing
ÖDisconnect the receiver and the connected devi-
ces from the power supply.
ÖDisconnect the antenna cable from the receiver.
ÖRemove the batteries from the remote control if
you do not use the receiver for a long period of
time.
ÖPackage the receiver, the cables and the remote
control in the original packaging.
ÖStore the receiver and all accessories in a dry
and dust-free location.
ÖProtect the receiver from frost.
Cleaning
ÖClean the receiver's housing using a dry cloth.
▲
Risk of electric shock!
No fluid must enter the receiver. Never clean it
with a wet cloth.
Prior to cleaning, remove the mains plug from the
mains socket.
Attention!
Do not use cleaning agents which contain sol-
vents, such as benzene or thinner. These agents
may damage the surface of the housing.
Rectifying malfunctions
Symptom Possible cause and remedy
The view in the display The power cable is not connected.
does not light up. Connect the power cable to the mains socket.
The mains switch is not switched on.
Switch the mains switch on.
No sound and no picture, The receiver is in standby mode.
the time display at the Press the "Power" key. The receiver switches on and the
receiver is lighted. channel is shown on the TV screen.
No sound or picture. No signal or a weak signal only.
Check the cable connection to the receiver and from the receiver to the
connected devices.
Align the antenna.
The TV set does The system is not connected correctly.
not show a picture. Check the SCART or HF cable's connection.
The TV set is not in AV mode.
Switch the TV set to the relevant AV input.
Poor picture, The antenna is not aligned correctly.
locking error Align the antenna.
The remote control The batteries are spent.
does not function. Replace the batteries with new ones.
The remote control is not being pointed properly.
Point the remote control at the front of the receiver and make sure that nothing
is positioned between the remote control and the receiver.
If a malfunction still cannot be rectified, please con
tact your specialist dealer.
CL_BDA_DVB_T774_GB_ka2.qxd 08.01.2008 17:26 Uhr Seite 44