Operation Manual

33
ENGLISCH
Connection schematic
Commissioning
ÖInsert the mains plug of the receiver in a regula-
tion power socket with PE for 230 V, 50 Hz.
ÖPress the power switch „ “ on the front side of
the device.
ÖInsert the connected devices' mains plug into the
mains socket and switch these on.
ÖSwitch on the AV channel on the TV set.
Please refer to your TV set's operating instruc-
tions for information on how to switch the "AV"
channel on.
Initial Installation
The first time the device is switched on the start win-
dow of the installation assistant appears. With the
help of this installation assistant you can easily carry
out the most important settings of the receiver.
ÖUse the “▼ CH-” and “▲ CH+” arrow keys to
select the desired option. Select by using the
“ VOL+” and “ VOL-” arrow buttons.
Confirm your selection with the "OK" button.
ÖAs soon as the Installation assistant has finished
the search run (100%), the device switches to TV
mode.
Remote control
The remote control requires two Micro LR 03/AAA
1.5 V batteries.
ÖOpen the battery compartment.
ÖInsert two batteries into the battery compartment,
observing the specified polarity.
ÖCarefully close the battery compartment lid again
until the lid engages.
ÖReplace dying batteries within good time.
ÖIt is not permitted to use odd batteries or new
and used batteries together.
ÖIf a battery has leaked, put on protective gloves
and clean the battery compartment with a dry
cloth.
▼ ▲
I
Attention!
Batteries may contain toxins which cause damage
to the environment. Batteries must therefore be
disposed of according to the applicable legal
regulations under all circumstances. Never dispo-
se of batteries in normal domestic waste. Never
place the batteries in fire.
CL_BDA_DVB_T774_GB_ka2.qxd 08.01.2008 17:26 Uhr Seite 33