Operation Manual

Rectifying malfunctions
48
Rectifying malfunctions
Symptom Possible cause and remedy
The power cable is not connected.
Connect the power cable to the mains socket.
The view in the
display does not
light up.
The mains switch is not switched on.
Switch the mains switch on.
No sound or
picture, the LED on
the receiver lights
up.
The receiver is in standby mode.
Press the "Power" key. The receiver switches on and the
channel is shown on the TV screen.
No sound or
picture.
No signal or a weak signal only.
Check the cable connection to the receiver and from the
receiver to the connected devices.
Align the antenna.
The system is not connected correctly.
Check the SCART or HF cable's connection.
The TV set does
not show a picture.
The TV set is not in AV mode.
Switch the TV set to the relevant AV input.
Poor picture,
locking error
The antenna is not aligned correctly.
Align the antenna.
The batteries are spent.
Replace the batteries with new ones.
The remote control
does not function.
The remote control is not being pointed properly.
Point the remote control at the front of the receiver and
make sure that nothing is positioned between the remote
control and the receiver.
If a malfunction still cannot be rectified, please contact your specialist
dealer or the manufacturer.