Operation Manual

39
4. Open the ll opening (13).
5. Fill the tank up to the maximum mark. Do not overll!
6. Close the ll opening.
7. You can now continue ironing.
When you have nished
1. Always set the temperature control to “MIN” after use.
Remove the mains plug from the socket.
2. Allow the device to cool down before you put it away.
Cord and pipe storage
• Wind the mains cord around the cord groove on the foot of
the base.
• Place the connection pipe in the cord clip.
Replacing the scale lter
1. Turn off the appliance.
2. Disconnect the mains plug from the mains.
3. Remove the water tank.
4. Remove the anti-scale lter cartridge.
5. Install the scale lter cartridge as described in “Before initial
operation”

“Inserting the anti-scale lter” .
Cleaning
WARNING:
• Always remove the mains lead before cleaning!
• Wait until the machine has cooled down completely!
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or re.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Children shall not perform cleaning without supervision.
• Clean the casing with a slightly damp cloth.
• Clean the sole plate and the rest with a slightly damp cloth.
• Any residual water can remain in the water tank, but should
be poured out if it has been in the tank for a prolonged
period.
Troubleshooting
Fault Possible Cause Remedy
Device does not
work.
Faulty mains socket Try another socket.
The device
suddenly stops
working during
operation.
Is the electric circuit
overloaded?
Check the house fuse.
No steam is
generated.
The lime lter
cartridge is mission
or has not been set
correctly.
Check the position of
the lime lter cartridge.
The water tank has
not been installed
correctly.
A "click" conrms that
the water tank has
been set correctly.
Fault Possible Cause Remedy
Water leaks
from the
soleplate.
The temperature is
set too low.
Select a temperature
between “
” and
“ ”.
Loud noises
during steam
operation
The tank is empty. Check the tank.
Fill tank with water.
Technical Data
Model: ........................................................................... DBS 3611
Power supply: ................................................... 230 V~, 50/60 Hz
Power consumption: .........................................................2200 W
Protection class: ........................................................................... I
Maximum lling quantity of the water tank: .................... 2.3 litres
Net weight: ........................................................... approx. 2.90 kg
The right to make technical and design modications in the
course of continuous product development remains reserved.
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance
with the latest safety regulations.