Installation Guide

Assembly Instructions
Solar panel installations
Choose a sunny location to mount the solar panel.
(There are two ways to assemble the Solar Panel.)
Pillar Mounted
1) Carefully remove the Solar lamp and all of the fittings out of the box.
2) Setting the “L” Shape Screw (1) to solar panel (8) with PA3*15 Screw (4). (shown in figure 1)
3) Connect “L” Shape Screw and Bracket for solar panel (6) and “U” Shape Screw (5). (AS shown in figure
2)
4) Tumble in the “L” Shape Screw to Pillar and twist the “U” Shape Screw tightly. (AS shown in figure 3)
Wall or Deck Mounted
1) Predrill 4 holes to align with bracket , tap anchors into wall. (as shown in figure 4).
2) Attach the Bracket to the solar panel with the 1 -PA3*15 Screw provided. (As shown in figure 5)
3) Mount the Bracket on the wall or deck with 4 - PA4*35 Screws provided. (As shown in figure 6)
4) Adjust the angle of Solar Panel to make sure it can get maximum sunlight, then twist the “U” Shape
Screw Under the Solar Panel tightly. (As shown in figure 7)
Lamp installations
1) Remove the bracket (10) from the lamp body. (As shown in figure 8)
2) Choose the location for the security light . (As shown in figure 9)
3) Pre drill holes, tap anchors into wall. (As shown in figure 10)
4) Mount the bracket with 3Pcs PA4*35 screws provided. (As shown in figure 11)
5) Slide the security light onto the bracket. (As shown in figure 12)
6) Adjust the angle of the lamp sensor (2) and “SENSOR LEVEL” & “DURATION”(As shown in figure
14) as per your requirements. (As shown in figure 13)