Installation Guide

Mod. SL489
3PK Solar Path Light
Lighting Instructions
Location of the Solar Panel Controller
For best results, locate the solar panel controller in a position where it can get direct
sunlight, and free from cover and shade. (As shown in figure 1). Make sure that the solar
panel is not going to be affected by any other light source.
Assembly Instructions
Solar Panel Controller Installation
1) Carefully remove the unit and all fittings from the box.
2) Assemble the mounting pole to the ground stake. Push the stake directly into the
ground at desired location.
3) Attach the Solar panel controller head to the mounting pole carefully and adjust to face
direct sunlight.
4) Adjust the switch under the solar panel to “AUTO” position.
Solar Light Fixture
5) Attach the lamp heads to the posts using the hardware provided.
6) Mount the lamps on a flat surface with the screws provided or use the ground stakes.
7) Choose the desired direction of the light beam and connect the wire to the solar panel
controller on the back of the unit. (As shown in Figure 2)
Replacing the Battery
For best results the batteries should be replaced every 12 months.
1) Turn the switch to off on the back of the solar panel controller and remove the 4
screws.
2) Replace the batteries with new 1.2 v 900 mAh AA rechargeable batteries.

Summary of content (6 pages)