User manual

Trimming
Aileron and rudder trim is not provided and not required. Static trim tabs can be adjusted
on the ground to level out production tolerances.
To adjust the aircraft as load changes the horizontal tail plane can be trimmed as a whole
by an electrical motor. The Fw 190 A-3 uses two push buttons, all other aircraft use a See-
saw Button (left click-hold, right click-hold) to trim the tail plane. The buttons are located in
the left console along with a trim indicator (Figure 1).
Fig. 1
Radio Operation
The Fw 190's FuG VII and FuG 16 radios were only adjustable on the ground, accessible
through a service flap on the left fuselage side. The pilot had some limited control using
remote controls located in the left cockpit console. However, frequencies could only be
adjusted on the ground.
The wartime Radio's remote controls in the cockpit's left console are adopted to provide
some basic FS functionality from within the 3d environment. Since there were no
indicators of any sort we relate on the tool tip function within FS to gather feedback on the
switches and dial's status. Whom it is to cumbersome can use the default 2d Bendix radio
which is build into the aircraft.
A note on tool tips: There is a known bug in FSX that causes tool tips to not show up when
in DX10 preview and full screen mode. Workaround: Toggle Alt+Enter to go to windowed
mode.
27