User`s guide

E-5
Note: When a function is changed from the control
panel or remote control there will be a corresponding
indicator (see Figure 7) on the upper-right of the
projection screen. The indicator shows the function
changed and the level selected by the control panel or
remote control. When the function is turned off, the
corresponding indicator will flash 5 times and then
fade off.
NOTE: PLEASE OPERATE REMOTE TRANSMITTER
AT A SLOW MEASURED PACE. PRESS THE
REMOTE CONTROL BUTTONS WITH AN EVEN
MOTION AND GENTLE PRESSURE. REPEATEDLY
PRESSING BUTTONS IN RAPID SUCCESSION
MAY CAUSE THE TRANSMITTER TO MALFUNCTION.
DISPOSAL OF USED BATTERIES
REPLACING THE REMOTE CONTROL BATTERY
When the remote control stops operating or its range seems
reduced, it is time to replace the battery with a new one.
1. The battery compartment is located on the back end of the
remote.
2. Press and slide the battery door open and remove
the old battery.
3. Insert 2pcs AAA batteries, checking that the + and - sides
of the battery match inside the battery compartment.
4. Replace the battery compartment door.
NOTE: Do not mix old and new batteries.
Do not mix alkaline, standard (carbon zinc),
or rechargeable (nicad, nimh, etc.) batteries.
Do not ingest.
Figure 7
on the upper-right of front projection screen
Battery may contain hazardous substances which could endanger the environment
and human health.
This symbol marked on the battery and/ or packaging indicates that used battery shall not be treated
as municipal waste. Batteries should be disposed of at an appropriate collection point for
recycling.
By ensuring the used batteries are disposed of correctly, you will help prevent potential
negative consequences for the environment and human health. The recycling of materials
will help to converse natural resources.
For more information about recycling of used batteries, please contact your local municipality waste
disposal service.
As an important safety feature, the heating element is designed with a delayed activation sequence.
Therefore, when the heater is turned ON it will take several minutes for the unit to begin blowing hot air.
Subsequently, the fan blower will continue to run for several minutes after the heater is switched OFF.
If heater doesn’t work, but Power and Heater switches are in the “ON” position and thermostat is set
on “HI”, the product is on the protected status, then turn all switches to the “OFF” position and
unplug the unit from the wall outlet for 30 minutes. After 30 minutes plug the unit back into wall outlet,
and operate as normal.
Figure 6: Remote Control
36EB111-GRC
36EB221-GRC
36EB110-GRT
36EB220-GRT