User's Manual

Speaker Operation
Note:
When transmitting over long distances, the audio signal becomes weaker
and interference increases.
If the source signal is too weak for reception, the transmitter automatically
switches off after approximately four minutes to protect the unit and save
power. If the source signal returns to an adequate level, the transmitter
automatically switches back on.
Power Off
To switch off power, press the ON/OFF button on the front panel of the
speaker. The transmitter will automatically switch off if there is no audio
signal detected for approximately four minutes.
Volume Control
To adjust speaker sound level, press the +/- buttons located on the front
panel of speaker until the desired volume is reached.
This device must be used with the AC/DC adapter supplied in the
package.
Troubleshooting
No Sound
- Ensure the AC adapter is securely plugged into the wall outlet and the
transmitter DC IN jack.
- Ensure the speaker POWER button is in the ON position.
- Speaker batteries may be too weak. Replace with new batteries or connect
with the AC/DC adapter (not supplied).
- Ensure the connected audio device is switched on and producing a signal.
- Ensure that the volume level is set to a moderate level.
Distortion
- Ensure the speaker and transmitter are operating on the same frequency. If
not, press the AUTO TUNE button until both units are operating on the
same frequency.
- Switch the CHANNEL selector position (1 or 2) on the transmitter base and
press the AUTO TUNE button the speaker until the matching frequency is
reached.