User's Manual

P.2
COMPONENT IDENTIFICATION
TRANSMITTER
SPEAKER RECEIVER
INSTALLATION
TRANSMITTER
1. Insert the antenna tube into the antenna wire.
2. Connect the supplied AC/DC power adapter to an electrical wall outlet.
3. Plug the AC/DC power adaptor in the DC jack located on the rear of the
transmitter.
4. When the AC adapter is plugged in, the red POWER LED illuminates. If the red
POWER LED does not illuminate, make sure the adapter is plugged in.
Signal On Indicator (green) Power On Indicator (red)
Power On/Off Volume Up/Down Auto Tune
DC Jack
Power LED
Antenna