SP1190 900MHz Wireless Rock Speaker User’s Manual Please read before using the equipment
INTRODUCTION This 900 MHz wireless rock speaker system uses latest wireless technology that enables you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the system to any audio source such as Radio, TV, VCR, Hi-Fi and CD/MP3/VCD/DVD player. Without complicated wiring and installation with your Audio/Video equipments and rear channel amplifier, the system enables you to enjoy thrilling, lifelike sound in minutes. FEATURES 1.
COMPONENT IDENTIFICATION TRANSMITTER Antenna Power on indicator (blue) SPEAKER RECEIVER INSTALLATION TRANSMITTER 1. Insert the antenna tube into the antenna wire. 2. Connect the supplied AC/DC power adapter to an electrical wall outlet. 3. Plug the AC/DC power adaptor in the DC jack located on the rear of the P.
transmitter. 4. The rear of the transmitter has one audio cord that can be connected to audio output jack of TV, Monitor, VCR, Radio recorder, CD/MP3/VCD/DVD players or to headphone/earphone jack with the connector provided. Plug the adapter in the AC source and connect the audio plug to the audio source. As soon as the transmitter is receiving the audio signal, it will automatically switch on and the blue LED will light up. SPEAKER RECEIVER 1.
OPERATION 1. Turn on the audio source (TV or audio component) to which the transmitter is connected with. The blue LED on the transmitter will light up. 2. Select the channel 1 or 2 of the transmitter for best performance in your location. 3. Turn on the ON/OFF button on the speaker. Press the “AUTO TUNE” button to get the best tuning reception in the speaker. When the button is pressed, frequency tuning starts automatically and it stops when a signal is detected. 4.
5. Whenever you find frequency jam, move your channel switch from one channel to the other channel (there are two channels for selection) on the transmitter, and then press the “AUTO-TUNE” button on the speaker again. 6. Switching Off a) For protection of the transmitter and power saving, the transmitter will cut off automatically if there is no/weak operation input signal from audio source for 4 minutes. If the audio signal comes back, the transmitter will turn on automatically.
- Speaker’s battery capacity is low, connect the AC/DC adaptor to the speaker. - Ensure the TV or audio component is ON. - The volume of speaker is too low, adjust the volume to an appropriate level. DISTORTED - Press the “AUTO-TUNE” button on the speakers until matching the frequency of the transmitter. - Change the position of the channel selector on the transmitter. Press the “AUTO TUNE” button on the speaker. - Ensure the volume level of speaker is adjusted properly.
TECHNICAL SPECIFICATIONS Transmission Mode : UHF Carrier Frequency : 900 MHz Operation Voltage : Transmitter, DC 12.5V 150mA Speaker, built-in lead acid rechargeable battery or DC 15V 1.
