User's Manual

P.5
REMOTE CONTROL UNIT
1. Remove the battery cover at the rear of the remote control unit and insert 2
pieces “AAA” size battery provided into the battery compartment with the
correct polarity.
2. Place back the cover and close the battery compartment.
OPERATION
1. Turn on the audio source (TV or audio component) to which the transmitter is
connected with. The Blue LED on the transmitter will light up.
2. Select the channel 1 or 2 of the transmitter for best performance in your
location.
3. Turn on the ON/OFF button on the speaker (the ON/OFF button on the remote
control unit cannot be used as a primary device to switch on the speakers).
Press the “AUTO TUNE” button to get the best tuning reception in the speakers.
When the button is pressed, frequency tuning starts automatically and it stops
when a signal is detected. Tuning process can also be activated by pressing the
“AUTO TUNE” button on the remote control unit.
4. Volume can be adjusted up by
pressing “+” button or down by
pressing the button “-“ to the desired
listening level, or you can press the
“+” button or “-“ button” on the remote
control unit to adjust the volume level.
NOTE :
a). Keep a distance of the speaker up
to 7 meters apart from the
transmitter, and then press “AUTO
TUNE” button for the best
reception.