Use and Care Manual

PREPARATION
✓ READ SDS BEFORE HANDLING & APPLICATION
✓ Highly recommended to test a small inconspicuous area rst.
✓ TURN OFF SPRINKLERS FOR TWO DAYS PRIOR TO AND AFTER.
✓ Always protect neighboring surfaces including wood,
carpet, metal, landscaping and other non-masonry surfaces.
✓ Caution: Surface is slippery when wet.
✓ New concrete must cure for 28 days before sealer is apply.
INSTALLATION
1. Prepare surface by carefully and thoroughly removing all
traces of any foreign matter.
2. Apply 1st coat of Matte Sealer by a roller or sprayer.
Note: System thickness 1-2 wet mils. per coat. Do not allow to
puddle. Puddles will result in a white haze.
3. After 30 to 60 minutes, repeat step (2) for the 2nd coat.
4. A 3rd application may be required in high traffic areas. Cure
Time at 77°F: Dry to touch in 30 minutes, re-coat after 30 to 60
minutes. Light foot traffic after 12 hours. Allow full cure and
vehicle parking after 7 days.
Classic Coatings Systems • 255 Citation Circle, Corona, CA 92878 • [phone]
© 2015 Classic Coatings Systems Inc. All rights reserved.
A PREMIUM MATTE WATER BASED ACRYLIC SEALER
PHYSICAL CHARACTERISTICS & TECHNICAL DATA
• Coverage per liquid gallon 300-450 sq ft per gallon
• Abrasion - Excellent
• VOC 0 g/l
• Degree of Gloss – None. Matte Finish
• Solids content by weight: 29.40%
• Solids content by volume: 26.40 %
It is HIGHLY recommended that on-site samples and mock-ups
be made by the applicator. Representative test sections must
be produced for the owner’s approval in writing and to ensure
that applicators are familiar with the product and installation
procedures.
Disclaimer: The information and recommendations contained
herein are based upon data believed to be correct; however, no
guarantee or warranty of any kind, express or implied is made
with respect to the accuracy of the information contained here-
in. We accept no responsibility and disclaim all liability for any
harmful eects, which may be caused by exposure to our prod-
ucts. Customers and users of this product must comply with all
applicable health and safety laws, regulations and orders.
PRODUCT AVAILABILITY & TECHNICAL ASSISTANCE
Technical assistance and information is available by calling:
[phone]
www.classiccoatingssystems.com
HANDLING PRECAUTIONS:
Use only with adequate ventilation. An appropriate cartridge type
respirator must be used during application in conned areas. Avoid
contact with skin. Protective gloves, eyewear and clothing are recom-
mended.
PROP 65 WARNING:
Classic Coatings, as a blender of processed material in the State of Cal-
ifornia, is required by Proposition 65 to warn that one or more of the
components contained in the product contain chemicals known to the
State of California to cause cancer, birth defects or other reproductive
harm. The State of California (Proposition 65) requires this warning in
the absence of denitive testing to prove that the dened risks do not
exist. We believe this product complies with all other applicable state
and federal laws and regulations governing manufacturing, distribu-
tion and intended use. User is solely responsible for the legal disposal
of this container and/or its contents.
WARRANTY:
Classic Coatings products are warranted for one year after date of
purchase. Please refer to the Limited Material warranty for addition-
al clarication. NOTICE TO BUYER: DISCLAIMER OF WARRANTIES AND
LIMITATIONS ON OUR LIABILITY. We warrant that our products are
manufactured to strict quality assurance specications and that the
information supplied by us is accurate to the best of our knowledge.
Such information supplied about our products is not a representation
or a warranty. It is supplied on the condition that you shall make your
own tests to determine the suitability of our product for your particular
purpose. Any use or application other than recommended herein is the
sole responsibility of the user. Listed physical properties are typical and
should not be construed as specications. NO WARRANTY IS MADE,
EXPRESSED OR IMPLIED, REGARDING SUCH OTHER INFORMATION,
THE DATA ON WHICH IT IS BASED, OR THE RESULTS YOU WILL OBTAIN
FROM ITS USE. NO WARRANTY IS MADE, EXPRESSED OR IMPLIED, THAT
OUR PRODUCT SHALL BE MERCHANTABLE OR THAT OUR PRODUCT
SHALL BE FIT FOR ANY PARTICULAR PURPOSE. NO WARRANTY IS MADE
THAT THE USE OF SUCH INFORMATION OR OUR PRODUCT WILL NOT
INFRINGE UPON ANY PATENT. We shall have no liability for incidental
or consequential damages, direct or indirect. Our liability is limited to
the net selling price of our product or the replacement of our product,
at our option. Acceptance of delivery of our product means that you
have accepted the terms of this warranty whether or not purchase or-
ders or other documents state terms that vary from this warranty. No
representative is authorized to make any representation or warranty or
assume any other liability on our behalf with any sale of our products.
Our products contain chemicals that may CAUSE SERIOUS PHYSICAL
INJURY. BEFORE USING, READ THE MATERIAL SAFETY DATA SHEET &
FOLLOW ALL PRECAUTIONS TO PREVENT BODILY HARM.
REVISED: January 2021
MAINTENANCE
For interior only: Clean with water and soap only. Do not
use chemicals.
For exterior only:
Clean with water. Improper maintenance
will result in wearing out your surface. If this occurs, use
Classic Strip Away to remove sealers and stains in order to re
apply desired stain and sealer. Note that Classic Strip Away
will remove any coats of sealers and stains on your surface.
Matte Water Based Sealer