Operating instructions

6
Remove control head. Disconnect control cables, and blower switch , discard. Retain all
of the original hardware.
Remove the complete Heater Assembly and discard.
Locate on the drivers side the Fresh Air Inlet Box. Locate the transition duct between the
inlet box and the louver in the Instrument Panel. Remove transition duct only and discard.
NOTE: Drivers side air inlet box is same as passenger. Reference picture page 3.
NOTE: There is a template provide on page 26 of these instructions
Looking through the glove box opening locate the 1 ¼” dia hole that the heater
connection extended through. Also locate original hole that the heater assembly mounted
through. Drill and cut the holes as shown below.
NOTE: INSTALL (2) 1 ¼” CAP PLUG OVER ORIGINAL HEATER CONNECTION HOLES.
Caution: on the engine side of
firewall there is a brake line. Do
not drill through. It may be
necessary to carefully relocate
this line.
1 ¼” original heater
connection hole.
Original hole
5/8” dia. Hole
Drill 5/16” dia.
4” dia. Hole.
5/8” Dia. hole.
Brake line