Operating instructions

5
Locate on the passenger side and remove the
following components. Fresh air inlet box,
Fresh air transition duct, and the Push Pull
cable. Discard along with all of the hardware.
Remove attachment screw and clip located in
front of air inlet.
On engine side of the Firewall remove the
(4) screws as shown.
DRAIN COOLANT FROM RADIATOR.
Remove Heater hoses from heater coil at
firewall.
Locate defrost duct from the heater box to base of
the defrost distribution plenum.
Use sharp box knife and carefully trim duct
assembly flush with flange as shown.
Air Inlet Box
Discard
(3) #10 Nuts / Discard
Attachment Screw Discard
Fresh Air / Transition
Duct / Discard
Trim to flange.
(4) ¼-20 nuts
Remove amd Discard