Operating instructions

20
Locate tube support bracket, spacer, (1)
#10 x 1” machine srew and nut.
Attach bracket over tubes. Insert screw
through bracket, spacer and then through
previosly drilled hole.
Attach using the #10 nut.
Locate Hi / Low switch and electrical boot.
Attach this to the drier using a few drops of
oil on the connection.
Route wires along the discharge tube into the engine
compartment.
Reinstall the following components:
Center Hood Latch Assembly and
(2) horns.
Attach Liquid Hose to the #6 condenser tube and route
along the tower supports and connect to the #6 fitting on
the firewall. Use (2) #6 o-rings and a few drops of
mineral oil.
Attach the disharge hose to the discharge tube and then
to the compressor. Use (2) #8 o-rings and apply a few
drops of mineral oil.
Tighten all fittings.
LIQUID HOSE
DISCHARGE HOSE