Operating instructions

19
Slide Condenser Assembly
into place as shown. The lower
attachment locations should
line up with holes already in
the radiator support.
Attach using (4) #14 x ¾” tek
screws.
Tighten all screws.
Locate dimple in radiator core support just to the
left of the opening for the tubes to pass through
on the drivers side.
Drill a 3/16” diametre hole using the dipple as
the center.
Locate the Liquid Tube, and the
Discharge Tube.
Using (1) #6 o-ring and a few drops
of mineral oil attach liquid tube to
drier and pass through the opening in
the radiator core support.
Using (1) #8 o-ring and a few drops
of mineral oil attach discharge tube to
the condenser and pass through the
opening.
3/16” HOLE