Operating instructions

Caution: Carefully check under the Instrument Panel for all cables, electrical

harness, or Flex Ducting that might interfere with the safe operation of the vehicle.

Make sure that you cycle the Windshield Wipers to insure proper clearance of

mechanism.

INSTALL THE COMPRESSOR AND MOUNTING HARDWARE USING

INSTRUCTIONS SUPPLIED WITH KIT. BE SURE THAT COMPRESSOR IS

INSTALLED WITH FITTINGS 90 Deg. FACING DRIVERS SIDE FENDER.

Remove the following components

Center Hood Latch Assembly, and the

(2) horns. Retain original hardware.

Set aside for reinstallation.

Locate the Condenser Coil, (4)

Condenser mounting brackets,

(10) #10 x 3/8” screws, Drier

assembly, mounting bracket and

liquid tube.

Attach drier to the coil using the

liquid tube as a locator using (2)

#10 x 3/8” screws. Attach the

tube to the coil and drier using

(1) #6 o-ring on each fitting and

a few drops of mineral oil.

Tighten fittings. Be sure to use

backup wrench on condenser

fitting.

Loosely attach the (4) mounting brackets to the condenser as shown. Use (8) 10 x 3/8”

screws.